22.06 Butterfly
22.07 Elevator function
(Pic 22.9)
(Pic 22.8)
(Pic 22.10)
Function Details:
If the airplane structure has 1 aileron, 1 flap, 1 spoiler and 1 elevator, it can be used to adjust the rate of the corresponding
motion (the default rate is +30%). This function allows powerful brake operation by simultaneously raising the left and right ailerons
and lowering the flaps (camber flap, brake flap). It can be controlled by a switch or stick to achieve the best flight effect. If the
airplane structure does not have any one of the aileron, flap, spoiler or elevator, then there is no this function, and no icon will be
displayed. This function can be set in 5 conditions respectively.
Select the function and then adjust the relative parameter by touching the corresponding icon. Adjust the corresponding value
by moving the wheel. Select a switch(SWA~SWH、LSW) by touching it to enable or disable this function or select a stick or knob
(Ail、Ele 、Thro、Rud、VRA~VRE) to control the value.
For this example, adjust the aileron, aileron2, flap, spoiler and elevator to 20% and select the knob to control the value.
To the servo display function and then CH1 (aileron) and CH6 (aileron2) are displayed as picture 22.8 to limit the speed.
Function Details:
This function can adjust the proportion of the 2 elevators end points and the default is 100%.
There is no this functions if the airplane doses not have the elevator or 2 elevator linkage. The
function icon will not be shown on the screen. This function can be set in 5 conditions respectively.
Select the desired “Down” or “Up” and move the wheel to adjust the corresponding value.
For this example: The airplane has 2 elevators. Adjust the Down and Up value to 75%. In this
situation, the elevators end points as shown in picture 22.10.
Vra to the far right
http://www.flysky-cn.com
50
To Next Page
Loading...
