5 McCready Functions
If the TASProbe is available then the VARIO SD provides some data related with the McCready theory
like the Speed to Fly, or McCready setting. The Speed to Fly is the TAS value which maximizes the
average Cross Country speed considering a certain average thermal speed. This value is independent of
the wind speed, because the fastest average speed achievable through the air corresponds to the fastest
achievable average ground speed. To calculate the Speed to Fly the VARIO SD takes in account the polar
and the average thermal speed. The value is shown on the
SpeedToFly
data eld.
Note: Traditional the average thermal speed used to calculate the Speed to Fly is manually
set by the pilot (McCready Ring). On the VARIO SD this value is calculated by averaging the
last thermals climbed.
Conversely, for each TAS (Speed to Fly) value there is a average thermal speed which maximizes the
Cross Country speed. This value is also calculated by the VARIO SD and shown on the
McRdyNxtThrm
data eld. Additionally, the
McRdyNxtThrm
value can also be visualized on the
Double Bar Analog Vario
(see Section 3.1.3). On the example of the Figure 5.1 Next thermal indicator points to 3.5m/s, while
the Average Thermal shows something around 2.1m/s. Ideally, they should point the same value, so the
pilot should reduce their speed. Naturally, he could maintain speed if he expects that the next thermal is
stronger.
Figure 5.1: McCready Indicator
24
To Next Page
Loading...
