Flymo EasiLife 200 - Page 29

3.10.10 ECO mode
If ECO mode is activated, it switches off the
signal in the boundary loop, the guide wire and
the charging station, when the product is parked
or is charging.
Note: Use
ECO mode to save energy and avoid
interference with other equipment, for example
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
3.10.10.1 To set the ECO mode
1. Do steps 1–3 in To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure Settings >
Installation > ECO mode
.
3. Push the OK button to select the ECO
mode
.
4. Push the BACK button.
3.10.11 To avoid collisions with the mower
house
If you have installed a mower house (available as
accessory), the wear on the product and the
mower house decreases when you select
Avoid
house collisions .
1. Do steps 1–3 in To get access to the menu
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Installation > Mower house > Avoid house
collisions
.
3. Push the BACK button.
Note:
If
Avoid house collisions is selected it can
result in grass that is not cut around the charging
station.
3.10.12 FrostSense
The grass is extra sensitive to wear if the yard is
covered with frost. If the FrostSense is activated,
the product is not allowed to start to cut the grass
if the temperature is below 5° C / 41° F.
Note:
The
FrostSense is located inside the
chassis and there can be a delay compared to
the ambient temperature.
3.10.12.1 To set the FrostSense
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Installation > FrostSense .
3. Push the OK button to select FrostSense .
4. Push the BACK button.
3.10.13 Bluetooth
®
The product can connect to mobile devices that
have the Flymo app installed. Flymo is a free app
for your mobile device. The short-range
interaction with the product is called Bluetooth
®
.
When pairing between the product and app has
been confirmed, you have access to the menus
and functions as long as you are within short-
range (Bluetooth
®
).
3.10.13.1 To pair the Flymo app and the product
1. Download the Flymo app on your mobile
device.
2. Do steps 1–3 in
To get access to the menu
on page 23 .
3. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Installation > Bluetooth > New pairing
.
4. Follow the instructions in the app.
3.10.14 General
In General you can change the general settings
of the product.
3.10.14.1 To set the time & date
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Time & Date .
3. Use the arrow buttons to set the time and
then push the BACK button.
4. Use the arrow buttons to set the date and
then push the BACK button.
5. Use the arrow buttons to set the time format
and then push the BACK button.
1392 - 001 -
Installation - 29