FlySky FS-MG41 - Instructions; Power On Procedure; LED Indicator Meanings; Binding Process

5
4.Instructions
After setting up, follow the instructions below to operate the system.
Follow the steps below to turn on the transmitter:
1. Check to make sure that that battery is fully charged and installed correctly.
2. Toggle the switch to the [ON] position. When active the R.LED will be lit.
3. Connect the receiver to power.
• For safety always power on the transmitter before the receiver.
4.3Binding
The transmitter and receiver have already been bound at the factory.
1. Turn on the transmitter while holding the bind button to enter bind mode. G.LED will start
flashing quickly.
• Once in bind mode release the bind button.
2. The receiver will power on and wait for 1 second ,if without connection, it will enter the
matching code automatically;
3. Once binding is successful the receiver’s LED will keep on.
Note: When binding, put the transmitter into bind mode first, then the receiver.
4.1PowerOn
However if the receiver needs to be replaced or additional receivers bound follow these steps:
Note
• Operate with caution in order to avoid damage or injury.
Note
• Make sure that the throttle is at its lowest position and the switches are set to their up
position.
• applicabletotheFS-MG4transmitterandtheFS-R4Areceiver.Differentreceivershave
differentbindprocedures.FormoreinformationvisittheFLYSKYwebsiteformanualsand
otherrelatedinformation.
• Productinformationisupdatedregularly,pleasevisitourwebsiteformoreinformation.
1. R.LED： The red power indicator;
2. G.LED： The green status indicator;
3. Car battery: Two colors light for battery volume display (hereinafter referred to as D3)
• When the power is high, the D3 green keeps on
• When the power is medium, the D3 yellow keeps on
• When the power is low, the D3 red keeps on
• When the power is o󽗈, the D3 red slow 󽗊ash
• When the receiver drops the code, the two-colors light is o󽗈
4.2LED Indicator