FlySky FS-MG41 - Stick Calibration; Power Off Procedure

FS-MG41
Digital Proportional Radio Control System
6
4.4StickCalibration
This function is used to set the neutral position for throttle and wheel.
Every transmitter is calibrated before leaving the factory, however if recalibration is
required,please follow these steps:
1. Turn and hold the wheel as far clockwise as it will turn, hold the throttle all the way
forward, then turn on the transmitter in calibration mode.
• The R.LED and G.LED will 󽗊ash twice.
• Car Battery the D3 yellow keeps on
2. Calibrate wheel: Turn the wheel completely clockwise, then completely counterclockwise.
• When calibration is completed the R.LED will be o󽗈.
• Car Battery the D3 red keeps on
3. Trigger calibration: Pull the trigger back then forward as far as it will go.
• When calibration is completed the G.LED will be o󽗈.
• Car Battery the D3 Green keeps on
4.Both Wheel and rigger are Calibration passed
• the two-colors light is o󽗈
5. Once calibration is complete press the bind key to save and exit.
4.5PowerO󽗈
Danger
• Makesuretodisconnectthereceiverpowerbeforeturningo󽗈thetransmitter.Failure
todosomayleadtodamageorseriousinjury.
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Toggle the transmitter's power switch to the off position.