Powering On
1. Check to make sure that the
battery is fully charged；
2. Press both power buttons
until the screen turns on.
Powering O
1. Power o the receiver.
2. Press and hold both power buttons until the screen turns o.
After powering o the transmitter wait for 3 seconds before
turning it on again.
Always power off the receiver before the transmitter.
Powering o the transmitter before the receiver may lead to
loss of control of the model.
If any switches are not at their
highest positions, or the throttle
is not at its lowest position, the
system will prompt: “Switch
is not in the highest position,
throttle is not at the lowest
position”. The transmitter will show which switches are not in
the correct position by highlighting them in red on a diagram.
To Next Page
Loading...
