removed by using a damp cloth and mild household detergent. Brass parts of the firefront may be cleaned using a suitable
brass cleaner. Replace the front centrally against the fire after cleaning. Do not use a damp cloth to clean cast iron fronts (Soho,
Finsbury and Arch models) as this can cause the fronts to rust.
PAINTED AREAS - These can be cleaned using a dry cloth.
COALS AND CERAMICS - Remove the firefront and place to one side. Remove the ceramic components. Gently clean in the
open air. Be careful not to create dust from the coals. Where necessary replace damaged components with genuine spares. Seal
scrap components in plastic bags and dispose of at proper refuse sites as directed.
Re-fit the ceramics carefully by referring to section 6.0 of these instructions.
Slide control models only : Ensure appliance is off and cool. The battery is located underneath the ignition unit, on the left hand
side of the burner. Insert 1 x ‘PP3’ (9 volt) battery.
5
© 2010 Focal Point Fires plc.
8.0 CLEANING - CONTINUED
GB IE
9.0 REPLACING THE BATTERIES
Item Part number
Pack of 16 coals F550038
Pack of 16 pebbles F550050
Front ceramic strip - coal F780008
Front ceramic strip - pebble F780017
Ceramic combustion matrix - coal F780007
Ceramic combustion matrix - pebble F780016
Ceramic pad set (includes rear pad and side pads) F550049
Oxypilot 9081 - All models F730006
Gas valve - manual control models F730066
Gas valve - slide control models F730067
Injector - stereo 81 - manual and remote control models F730046
Injector - stereo 82 - slide control models F730077
HT lead/piezo assembly F750081
Burner assembly - complete - manual control TRAY015
Burner assembly - complete - slide control TRAY087
10.0 LIST OF REPLACEMENT PARTS
To Next Page
Loading...
