Focusrite Clarett 4 Pre USB User Manual

12
When mixing, you can connect an additional pair of speakers (mid-eld, near-eld, etc.) to
LINE OUTPUTS 3 and 4 to check your mix on different types of speaker. You can easily congure
Focusrite Control to route the mix to these outputs as well as Outputs 1 and 2.
Main
Monitor
Speakers
Additional
Monitor
Speakers
IMPORTANT:
LINE OUTPUTS 1 and 2 incorporate “anti-thump” circuitry that protects your speakers if
the Clarett 4Pre USB is turned on while the speakers (and amplier if used) are connected
and active.
LINE OUTPUTS 3 and 4 do not have this circuitry.
If you’re using additional speakers connected to these outputs, we recommend you power
your Clarett 4Pre USB on rst,
then turn on the speakers or power amplier. But get into
the habit of following the general rule in any case - it is
always good audio practice to turn
on a speaker system of any kind
after turning on the equipment feeding it.

Focusrite Clarett 4 Pre USB Specifications

General

Brand	Focusrite
Model	Clarett 4 Pre USB
Category	Recording Equipment
Language	English