13
Connecting additional monitors
When mixing, you can connect several pairs of additional speakers (mideld, neareld, etc.) to output
pairs and use Focusrite Control to route your mix to the different outputs as desired, to check your
mix on the different speakers.
IMPORTANT:
MONITOR 1 and 2 outputs have “anti-thump” circuitry that protects your speakers if the
Clarett+ 8Pre is turned on while the speakers (and amplier if used) are connected and
active.
LINE OUTPUTS 3 to 10 do not have this circuitry. If you’re using additional speakers
connected to these outputs, power your Clarett+ 8Pre on rst, then turn on the speakers
or power amplier.
But get into the habit of following this general rule in any case - it is good audio practice
to turn on any speaker system
after
turning on the equipment feeding it.
To Next Page
Loading...
