22
To review the day-average test results, do the following:
1. Press and release to enter memory mode for average results with “
” and displayed on the screen. And then your 7-day average result
measured in general mode will appear on the display.
2. Press or to review 14, 21, 28, 60 and 90-day average results stored in
each measuring mode in the order of Gen, AC, then PC.
Note:
• Press and hold MAIN for 5 seconds to exit the memory mode or leave it without
any action for 3 minutes. The device will turn off automatically.
• If using the device for the rst time, the “---” icon will appear when you recall
the test results or review the average result. This indicates that there is no test
result in the memory.
• Control solution results are NOT included in the day average.
To Next Page
Loading...
