16
WARNING :
• While the meter is in transmission mode, it will be unable to perform a blood
glucose test.
• Make sure your device with iOS (5.0.1 or higher) or Android system has turned
on Bluetooth before transmitting the data and the meter is within the receiving
range.
• The USB port of meter DM30b is only for battery recharge. It does not have the
function of data transmission.
1. Make sure your meter is already paired with your device with iOS
(5.0.1 or higher) or Android system by following instructions of the
setting mode in Step 6.
2. Install the software on your device with iOS (5.0.1 or higher) or
Android system.
3. Data transmission
Turn o
n the Bluetooth on your device with iOS (5.0.1 or higher) or Android
system and keep it on, and your meter will be able to connected to the
device after measurement. You can view the data on your device.
BATTERY RECHARGE
Your meter comes with a built-in rechargeable Li-polymer battery. If the
low battery symbol
"
"appears on the screen indicating that the battery is low and it is time
to recharge the battery.
1. Connect the USB cable to the data port of the meter.
2. Connect the other end of cable to a free USB port on your personal
computer.
3. "USb" will appear on the display and the charging indicator will light up
in red when battery is recharging. After the battery is fully charged, the
red
light will turn green.
4. Remove the USB cable and the meter will automatically switch off.
To Next Page
Loading...
