13
hour. Press SET to confirm and go to
minutes, press Main button to add one
minute. Hold Main button longer to add
faster. Press SET to confirm and go to the
next alarm setting.
If you do not want to set an alarm, press
SET to skip this step.
If you want to turn off an alarm, find
the alarm number by pressing SET in
the setting mode, press Main button to
change from “ON” to “OFF”.
At the time of you
r alarm, the meter will beep and automatically turn on.
You can press Main button to silence the alarm and insert a test strip to
begin testing. If you do not press Main button, the meter will beep for 2
minutes then switch off. If you do not want to test at this time, press Main
button to switch off the meter.
Congratulations! You have completed all settings!
NOTE:
• These parameters can ONLY be changed in the setting mode.
• If the meter is idle for 3 minutes during the setting mode, it will switch off
automatically.
To Next Page
Loading...
