Force1 UFO5000 - Troubleshooting and Support; Common Drone Issues and Solutions

14
www.force1rc.com
TROUBLESHOOTING GUIDE
Problem Reason Solution
The LED indicator on the drone
ashes continuously after
connecting the battery, there
is no response from the remote
control.
The remote control and the
drone are not paired.
Refer to page 8 to pair again.
The drone is not responding. 1. The drone or the remote
control is turned o.
2. The batteries of the drone
or remote control are out of
power or damaged.
3. The batteries are not inserted
properly.
1. Turn on the remote and drone,
and ensure that the battery is
inserted properly.
2. Charge the batteries, use fully
charged batteries.
3. Insert the battery again
and ensure that they are
connected properly.
The motor does not respond to
the throttle lever and the LED
indicator on the drone ashes.
The drone battery level is too
low.
Charge the battery or replace it
with a fully charged battery.
The propellers spin but the
drone does not take o.
1. The propellers are damaged.
2. The drone battery level
is too low.
3. Propellers are installed in the
wrong drone quadrant.
1. Replace the damaged
propeller(s).
2. Charge the battery or replace
it with a fully charged battery.
3. Check the propeller
orientation and install the
propellers in the correct
quadrant on (pg. 5)