Introduction | 9
2.3.2 Form 3BL Finish Kit
Rinse bucket: Fill the rinse bucket with solvent to the FILL TO HERE marking before
washing prints. The rinse bucket includes a ground wire to prevent static discharge.
Formlabs recommends isopropyl alcohol or tripropylene glycol monomethyl ether.
Rinse basket: Place prints in the rinse basket, place the rinse basket into the rinse bucket,
and agitate to clean.
Rinse bottle: Remove resin trapped in cavities and internal channels of prints. Use clean
solvent. Formlabs recommends isopropyl alcohol.
Non-reactive nitrile gloves: Wear gloves when handling liquid resin, resin-coated surfaces,
or solvent. Wash skin with plenty of soap and water.
Battery operated solvent pump: Fill and empty the rinse bucket.
Build platform jig: Stabilize the build platform for the secure removal of prints.
Drying tray: Place washed prints on the drying tray to drip dry.
Flush cutters: Snip to separate prints from their supports. Cut with the flat side on the prints’
surface for minimal support marks.
Scraper: Remove prints from the build platform. Do not use the scraper to clean the resin
tank interior.
Removal tool: Pry under the raft to remove prints from the build platform. Do not use the
removal tool to clean the resin tank interior.
Tank tool: A two-part scraper for inspecting and cleaning the resin tank interior. Separate
tool for scraper function or combine for tongs.
1
2
3
4
5
6
7
8
9
10
11
1
2
3
4
5
6
7
8
9
10
11
To Next Page
Loading...
