3
A Flush Cutters. Use to carefully remove support tips from printed parts.
B Removal Tool. Apply pressure under the base generated by
PreForm to release the base of your parts from the build platform.
C Hydrometer. Float in IPA to measure the IPA’s resin concentration,
based on previous calibration in fresh IPA. See page 5.
D Scraper. Can be used to remove parts from the build platform, as well
as to carefully clean and inspect the resin tank for cured material.
E Tweezers. Use to handle small parts or to manipulate supports
after printing.
F Siphon Pump. Transfer IPA between the wash bucket and an IPA
storage container. See page 9.
TOOLS & STORAGE
11
11 11 11
LEFT STORAGE RIGHT STORAGE
11
To Next Page
Loading...
