Formlabs Form Wash - Form Wash Set-Up; Fill Wash Bucket with IPA; Connect Power Supply

To Next Page

To Previous Page

1. Fill Wash Bucket with IPA

Isopropyl alcohol (IPA) is a solvent used to remove uncured resin

from SLA 3D prints. Open the outer lid. Pour or siphon to ﬁll the wash

bucket with IPA to reach a level between the minimum (7.8 L) and

maximum (8.6 L) ﬁll lines. For more information about using a siphon,

see Changing the IPA on page 9.

NOTE For more information on buying, handling, safe storage, and

disposal of IPA see:

formlabs.com/ipa

2. Connect Power Supply

Connect the power cable to Form Wash and a power source.

FORM WASH SETUP

USB port provided for future updates.

Other manuals for Formlabs Form Wash