To Next PageTo Next PageWhat to do if there is no water at the shower or sinks in my Formula Boat?
If you have no water at the shower or sinks, first, check if the fresh water pump circuit breaker has tripped or is in the OFF position. If so, correct the problem, reset it, and turn the circuit breaker ON. Also check if the filter is plugged and clean it. Keep in mind that the fresh water tank might be empty.
Why is there no AC power in my Formula Boat?
If there is no AC power, check if the circuit breakers have tripped or are in the OFF position and correct the problem, then reset them. Also, check if the ground fault circuit interrupter has tripped, and if so, reset the button on the outlet and test.
What to do if the head will not flush on my Formula Boat?
If the head will not flush, first ensure that the head circuit breaker hasn't tripped or is in the OFF position. If it has, correct the problem and reset it, then turn the circuit breaker ON. Also, the holding tank might be full, so pump out the tank.
What causes low water pressure at only one sink in my Formula Boat?
Low water pressure at only one sink can be caused by a restriction or obstruction in the water line.
General welcome and overview of the owner's manual.
Outlines duties and responsibilities of the boat owner and operator.
Advice on protecting the environment while boating.
Explains warning symbols and terms used throughout the manual.
Details essential safety gear required for boat operation.
Guidance on preparing for and responding to emergencies.
Warnings and legal implications of operating under the influence.
Defines key terms and parts of the boat.
Provides key measurements for different boat models.
Technical details and capacities for the 271 Fastech model.
Technical details and capacities for the 382 Fastech model.
Explains the function of various engine and boat gauges.
Details the operation of different electrical switches on the boat.
Function and reset procedure for circuit breakers.
Explains the function of battery selector switches.
Safety and maintenance guidelines for the fuel system.
Explanation of the boat's 12-volt DC electrical system.
Procedures for connecting and using shore power.
Details on the fixed fire suppression system.
Essential checks before starting the engines.
Safety precautions and steps for fueling the boat.
Routine checks to perform before operating the boat.
Procedures for starting the boat's engines.
Precautions and techniques for high-speed operation.
Adjusting trim for optimal boat performance.
Techniques for safely docking the boat.
Recommended maintenance intervals and tasks.
Essential pre-operation checks for safety and function.
Guidelines for cleaning the boat's interior.
Maintaining the gelcoat finish and hull.
Maintenance and safety for the fuel system.
Methods to protect against galvanic corrosion.
Steps for preparing the boat for winter storage.
Procedures to prepare the boat for use after storage.
Common engine problems and potential causes.
Troubleshooting common electrical system issues.
Details of the manufacturer's limited warranty.
A log for recording maintenance and repair history.
A plan to leave with someone for safety.
General