16
To hang on a wall with screws
1. Tape the drill template sticker to the wall in the desired location.
5. Position the device so the
mounting holes line up with the
screws.
6. Place the mounting slots over the
screws and slide the device down
until the screws fit into slots.
2. Use the template to mark and drill the pilot
holes.
3. Insert the anchors into the holes.
4. Insert the screws into the anchors and
tighten, but not all the way—leave around
a 5mm gap between the screw head and
the wall.
Tip: Use bear claw screws. The screw heads of bear claw screws have a built-in
gap that fits well with the hanging holes. You can purchase bear claw screws from a
local or online hardware store.
To Next Page
Loading...
