Fortinet FortiFone FON-C71 - Disconnecting from the Wireless Network; Advanced Settings; Account; Network

Configuration Overview Page 19 FortiFone User Guide
• To delete the desired wireless network profile:
i. Select Delete or Delete All from the prompts list. If you delete your wireless network
profile, you will need to manually connect the next time Wi-Fi is enabled.
Disconnecting from the wireless network
To disconnect from the wireless network:
1. Tap Menu > Settings > Basic Settings > Wi-Fi > available networks.
2. Select the connected wireless network and then tap the Disconnect softkey.
Advanced settings
Account
You can register only one account on the FON-C71 IP conference phone.
To register an account via phone user interface:
1. Tap Menu > Settings > Advanced Settings (Default password: 23646) > Account.
2. Tap the Enter softkey.
3. Tap the or softkey to select Enabled from the Account Status field.
4. Enter the desired value in Label, Display Name, Register Name, User Name, Password and
SIP Server1/2 fields respectively.
If you use the outbound proxy servers, do the following:
5. Press the or softkey to select Enabled from the Outbound Status field.
6. Enter the desired value in the Outbound Proxy1/2 and Proxy Fallback Interval fields
respectively.
7. Tap the Save softkey to accept the change or the Back softkey to cancel.
To disable an account via phone user interface:
1. Tap Menu > Settings > Advanced Settings (Default password: admin) > Account.
2. Tap the Enter softkey.
3. Tap the or softkey to select Disabled from the Account Status field.
4. Tap the Save softkey to accept the change or the Back softkey to cancel.
Registering an account is configurable via web user interface at the path Account > Register.
Network
WAN port
If your phone cannot contact a DHCP server for any reason, you need to configure network
settings manually. The IP phone can support either or both IPv4 and IPv6 addresses.
To configure the IP mode via phone user interface:
1. Tap Menu > Settings > Advanced Settings (Default password: admin) > Network > WAN Port.
2. Tap the or softkey to select IPv4 IP, IPv6 or IPv4 & IPv6 from the IP Mode field.
3. Tap the Save softkey to accept the change or the Back softkey to cancel.