Fortinet FortiFone FON-C71 - Display; Sound

Configuration Overview Page 12 FortiFone User Guide
Display
You can configure the backlight to adjust the brightness of the LCD screen. Backlight status on
the LCD screen can be configured from the following options:
• Always On: Backlight is on permanently.
• Always Off: Backlight is off permanently.
• 15s, 30s, 1min, 2min, 5min, 10min or 30min: Backlight is turned off when the phone has
been inactive longer than the designated time.
To configure the backlight via phone user interface:
1. Tap Menu > Settings > Basic Settings > Display > Backlight Settings.
2. Tap the or softkey to select the desired value from the Backlight Time field.
3. Tap the Save softkey to accept the change or the Back softkey to cancel.
You can configure the contrast of the LCD screen to a comfortable level. The intensity of
contrast ranges from 1 to 10 and the highest intensity is 10.
To configure the contrast via phone user interface:
1. Tap Menu > Settings > Basic Settings > Display > Contrast.
2. Tap the or softkey to decrease or increase the intensity of contrast. The default
contrast level is 6.
3. Tap the Save softkey to accept the change or the Back softkey to cancel.
Sound
Ring Tones
Ring tones are used to indicate incoming calls. You can select different ring tones to distinguish
your phone from your neighbor’s.
To select a ring tone for the phone via phone user interface:
1. Tap Menu > Settings > Basic Settings > Sound > Ring Tones > Common.
2. Tap or to select the desired ring tone.
3. Tap the Save softkey to accept the change or the Back softkey to cancel. A ring tone for the
phone is configurable via web user interface at the path Settings > Preference > Ring Type.
To select a ring tone for the account via phone user interface:
1. Tap Menu > Settings > Basic Settings > Sound > Ring Tones.
2. Tap or to select the desired account, then tap the Enter softkey.
3. Tap or to select the desired ring tone. If Common is selected, this account will use the
ring tone selected for the phone.
4. Tap the Save softkey to accept the change or the Back softkey to cancel.
A ring tone for the account is configurable via web user interface at the path Account > Basic >
Ring Type.