Fortinet FortiGate FortiGate-3000 Installation Guide

Getting started Factory default FortiGate configuration settings
FortiGate-3000 Installation Guide 01-28005-0026-20041101 19
Factory default Transparent mode network configuration
In Transparent mode, the FortiGate unit has the default network configuration listed in
Table 3 .
Factory default firewall configuration
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can be accepted by or pass through the
FortiGate unit. To allow traffic through the FortiGate unit you can add firewall policies.
See the FortiGate Administration Guide for information about adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
The factory default firewall configuration is the same in NAT/Route and Transparent
mode.
Table 3: Factory default Transparent mode network configuration
Administrator
account
User name: admin
Password: (none)
Management IP
IP: 10.10.10.1
Netmask: 255.255.255.0
DNS
Primary DNS Server: 207.194.200.1
Secondary DNS Server: 207.194.200.129
Administrative access
Internal HTTPS, Ping
External Ping
Port 1 HTTPS, Ping
Port 2 Ping
Port 3 Ping
Port 4/HA Ping
Table 4: Default firewall configuration
Configuration setting Name Description
Firewall address All Firewall address matches the source or
destination address of any packet.
Pre-defined service More than 50
predefined services
Select from any of the 50 pre-defined services
to control traffic through the FortiGate unit that
uses that service.
Recurring schedule Always The recurring schedule is valid at any time.
Protection Profiles Strict, Scan, Web,
Unfiltered
Control how the FortiGate unit applies virus
scanning, web content filtering, spam filtering,
and IPS.

Fortinet FortiGate FortiGate-3000 Specifications

General

Brand	Fortinet
Model	FortiGate FortiGate-3000
Category	Firewall
Language	English