Getting started Next steps
FortiGate-3000 Installation Guide 01-28005-0026-20041101 25
If you are configuring the FortiGate unit to operate in Transparent mode, you can
switch to Transparent mode from the web-based manager and then use the setup
wizard to add the administration password, the management IP address and gateway,
and the DNS server addresses.
Next steps
Now that your FortiGate unit is operating, you can proceed to configure it to connect to
networks:
• If you are going to operate the FortiGate unit in NAT/Route mode, go to
“NAT/Route mode installation” on page 27.
• If you are going to operate the FortiGate unit in Transparent mode, go to
“Transparent mode installation” on page 39.
• If you are going to operate the or more FortiGate units in HA mode, go to “High
availability installation” on page 47.
To Next Page
Loading...
Need help?
General