Fortinet FortiGate Series

Configuring transparent mode Configuring
FortiGate Version 4.0 Desktop Install Guide
22 01-400-95522-20090501
http://docs.fortinet.com/ • Feedback
The following steps add two policies that allows all traffic through the Fortinet unit, to
enable you to continue testing the configuration on the network.
To add an outgoing traffic firewall policy - web-based manager
1 Go to Firewall > Policy.
2 Select Create New.
3 Set the following and select OK.
Figure 11: Creating an outgoing firewall policy
To add an outgoing traffic firewall policy - CLI
config firewall policy
edit <index_int>
set srcintf <name_str>
set srcaddr <name_str>
set dstintf <name_str>
set dstaddr <name_str>
set schedule always
set service ANY
set action accept
end
To add an incoming traffic firewall policy - web-based manager
1 Go to Firewall > Policy.
2 Select Create New.
3 Set the following and select OK.
Source Interface/Zone Select the port connected to the network.
Source Address All
Destination Interface/Zone Select the port connected to the Internet.
Destination Address All
Schedule always
Service Any
Action Accept
Source Interface Select the port connected to the Internet.
Source Address All
Destination Interface Select the port connected to the network.
Destination Address All