EasyManuals Logo

Fortinet FortiGate Series Install Guide

Fortinet FortiGate Series
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Configuring Additional configuration
FortiGate Version 4.0 Desktop Install Guide
01-400-95522-20090501 27
http://docs.fortinet.com/Feedback
Configuring FortiGuard
You need to configure the Fortinet unit to connect to the FortiGuard Distribution Network
(FDN) to update the antivirus, antispam and IPS attack definitions.
The FDN is a world-wide network of FortiGuard Distribution Servers (FDS). When the
Fortinet unit connects to the FDN, it connects to the nearest FDS. To do this, all Fortinet
units are programmed with a list of FDS addresses sorted by nearest time zone according
to the time zone configured for the Fortinet unit.
Before you can begin receiving updates, you must register your Fortinet unit from the
Fortinet web page. For more information, see “Register your FortiGate unit” on page 13.
Updating antivirus and IPS signatures
After you have registered your Fortinet unit, you can update antivirus and IPS signatures.
The FortiGuard Center enables you to receive push updates, allow push update to a
specific IP address, and schedule updates for daily, weekly, or hourly intervals.
To update antivirus definitions and IPS signatures
1 Go to System > Maintenance > FortiGuard.
2 Select the expand arrow for AntiVirus and IPS Options to expand the options.
3 Select Update Now to update the antivirus definitions.
If the connection to the FDN is successful, the web-based manager displays a
message similar to the following:
Your update request has been sent. Your database will be updated in
a few minutes. Please check your update page for the status of the
update.
After a few minutes, if an update is available, the System FortiGuard Center page lists
new version information for antivirus definitions. The System Status page also displays
new dates and version numbers for the antivirus definitions. Messages are recorded to the
event log indicating whether or not the update was successful or not.
For more information on FortiGuard configuration, see the FortiGate Administration Guide.
Note: Updating antivirus definitions can cause a very short disruption in traffic currently
being scanned while the Fortinet unit applies the new signature database. Schedule
updates when traffic is light, for example overnight, to minimize any disruption.

Table of Contents

Other manuals for Fortinet FortiGate Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortinet FortiGate Series and is the answer not in the manual?

Fortinet FortiGate Series Specifications

General IconGeneral
ModelFortiGate Series
CategoryFirewall
ThroughputVaries by model
InterfacesVaries by model
Concurrent SessionsVaries by model
VPN SupportYes
High AvailabilityYes
Firewall ThroughputVaries by model
VPN ThroughputVaries by model
IPS ThroughputVaries by model
NGFW ThroughputVaries by model
Threat Protection ThroughputVaries by model
New Sessions per SecondVaries by model
Power SupplyVaries by model
Security FeaturesFirewall, IPS, Application Control, Web Filtering, Antivirus, VPN
Virtual DomainsYes
Form FactorDesktop, Rackmount

Related product manuals