Fortress Technologies FJW70M17 User Manual

2
INSTALLATION INSTRUCTION
Installation Area
 Stability is important to prevent the washer from wandering.
 Make sure that the washer does not stand on the power cord.
 Keep the washer far away from the heat resources such as coal
or gas.
 Please leave enough space for the washer. (Fig. 1)
Fig. 1
Remove Package
 Remove the package and take out the base foamed
cushion. (Fig. 2 )
 Open the lid of the washer and take out the
accessories.
 A trial operation or washing on the base foamed
cushion is strictly forbidden.
Fig.2
Installation of the Drain Hose
Note: Use only the new supplied water hose-sets with
the new appliance. Do not use a hose from your existing
appliance or a hose that has been used previously.
 Completely seat the drain hose over the drain
connector.
 Fix and tighten it with a hoop. (As shown in the Fig.3
and you can use a plier to finish it.)
Fig.3
Installation of the Water Inlet Hose
 Put the water inlet hose (with metallic filtering bag)
screw on to the tap.
 Tightly screw another end of the water inlet hose on the
water inlet valve (with rubber seal ring inside). (Fig. 4)
Note: When tightening the clamping nut, evenly
apply the force, and do not twist the water inlet
valve to avoid breaking of water inlet valve joint.
Base foamed cushion
Fig. 4
Clamping nut
Water inlet hose

Fortress Technologies FJW70M17 Specifications

General

Brand	Fortress Technologies
Model	FJW70M17
Category	Washer
Language	English