HTTP Port: By default, the HTTP port is set to 88. Also, they can be assigned with another port number
between 1 and 65535. But make sure they can not be conflict with other existing ports like 25, 21.
Another way to change the HTTP port NO.
Step 1, Open the Equipment Search Tool, select the camera you would like to change the port of, right click on
the IP address, and click on Network Configuration, this brings up the network configuration box as shown in
following figures.
Step 2: Enter the username and password of the Administrator (default username is admin with a blank
Select which camera
you'd like to change the
port for, and right click.
Enter the Username and
password, click OK.
To Next Page
Loading...
