4 Advanced Camera Settings
Click the button Settings, goes to Administrator Control Panel to make advanced camera settings.
4.1 Setup Wizard
After logging in for the first time, you will go to "Setup Wizard" automatically. Here you can set the basic
parameters of camera, such as the camera name, camera time, IP configuration and so on.
4.2 Device Status
Device Status contains four columns: Device Information, Device Status, Session Status and Log, it will show
you various information about your camera.
4.2.1 Device Information
Camera Model: The model of the device.
Camera Name: The Device Name is a unique name that you can give to your device to help you identify it.
Click Basic Settings and go to Device Name panel where you can change your camera name. The default
device name is anonymous.
Camera ID: Display the MAC address of your camera. For example Device ID is 008414350787, the same
MAC ID sticker is found at the bottom of the camera.
To Next Page
Loading...
