NVR User Manual
www.foscam.com
Alarm Settings
[Motion Detection]
Follow the steps to set the motion detection parameters. In the live view mode, once a motion
detection event takes place, the NVR can analyze it and perform many actions to handle it. Enable
motion detection function can trigger certain channels to start recording, or trigger full screen
monitoring, output alarm, send Email, upload figure to FTP, buzzer alarm and so on.
In the live view mode, there are icons at the right bottom of the screen for each channel.
The Icon indicate alarm was triggered.
The Icon indicate the IPC is recording.
In this chapter, you can follow the steps to schedule a record which triggered by the detected motion.
Choose Menu > Settings > Alarm Settings > Motion Detection in the Menu interface. The Motion
Detection interface is displayed.
The output resolution of the NVR.
Configure the transparency of the NVR output interface.
Configure the sensitivity of the mouse.
To Next Page
Loading...
