4.5.4 IR LED Schedule
On this page you can set the schedule time for switching IR LED lights. When parameter Mode is set to the
Schedule on the Live Video window, At these schedule time, the IR LED lights will be turned off.
4.6 Detector
4.6.1 Motion Detection
IP Camera supports Motion Detection Alarm, when the motion has been detected, it will send emails or
upload images to FTP.
To enable motion detection, follow the steps below:
1 Enable Motion detection
2 Sensitivity---- It supports three modes: Low, Middle and High. The higher the sensitivity, the camera will be
more easily alarmed. Select one motion sensitivity.
3 Trigger interval--- The interval time between two motion detections. Here supports 5s / 6s / 7s / 8s / 9s / 10s
/ 11s / 12s / 13s / 14s / 15s. Select one interval time.
4 There are some alarm indicators:
A Camera Sound and PC Sound
To Next Page
Loading...
