39
WARNING
Do not start the bandsaw before fastening the machine, assembling and adjusting
the workbench, checking belt tension and safety devices. Only after performing these
tasks you can connect the saw to the power supply. Otherwise the bandsaw could start
suddenly and cause personal injuries.
This machine is delivered almost completely assembled. Before use you must:
1. Fix bandsaw’s base
2. Assemble the workbench
3. Adjust the workbench
4. Assemble the fence’s rail
5. Assemble the fence
6. Connect the dust collection device
7. Tighten the blade
I. Bandsaw fastening
The bandsaw can be fastened to a surface or assembled
on the four legs that are included in the package. If you
want to fix it on a surface:
1. Drill 4 holes on the surface on which you want to
fix the bandsaw, while taking into consideration
the measurements illustrated on the figure on the
side.
2. Use 4 locking devices suitable with the surface
and fix the saw.
If you want to use the legs and the bars included in the package, put the machine on its side
and:
1. Assemble the 4 legs to bandsaw’s blade with 8 screws and the corresponding nuts and
washers.
2. Assemble the 4 bars with the screws and the washers.
3. Straighten up the bandsaw.
4. Firmly tighten all the screws.
5. Assemble the two wheels on the two left legs, to make the transport easier.
II. Workbench assembly
1. Tighten the slot screw (34) to the bottom side of the workbench.
2. Place the workbench on the table’s guide.
3. Fix the workbench on table’s side with washers and 4 screws
with post (35).
ASSEMBLY OF THE SAW BLADE
To Next Page
Loading...
