Chapter 3 BIOS Description
38
vOnboard FDC Controller
This option is used to set whether the Onboard FDC Controller is enabled.
The available setting values are: Disabled and Enabled.
vOnboard IrDA Port
This option is used to set the Onboard IrDA Port .
vIrDA Duplex Mode
This item enables you to determine the infrared function of the onboard infra-
red chip.
vOnboard Parallel Port
This option allows you to determine onboard parallel port controller I/O ad-
dress and interrupt request (IRQ).
vParallel Port Mode
Select an address and corresponding interrupt for the onboard parallel port.
The setting values are: SPP, EPP, ECP, ECP+EPP.
vECP Mode Use DMA
When the Parallel Port Mode is set to ECP or ECP+ EPP, this option is used to
select the channel for the ECP mode.
SuperIO Device Menu
vKB Power ON Password
This option is used to set the KB Power ON Password.
vHot Key Power ON
When the POWER ON Function set to Hot KEY, use this item to set the hot
key combination that turns on the system.
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn
To Next Page
Loading...
Need help?
General
