To Next Page

To Previous Page

Chapter 3 BIOS Description

PnP/PCI Configurations

PnP/PCI Configurations Menu

v Init Display First

This option is used to set which display device will be used first when your PC

starts up.

v Reset Configuration Data

This option is used to define the system resource control scheme.If all cards

you use support PNP,then select Auto (ESCD) and the BIOS wil automatically

distributes interruption resources.If the ISA cards you installed not support-

ing PNP, you will need to select “Manual” and manually adjust interruption

resources in the event of hardware conflicts.However,since this motherboard

has no ISA slot,this option doesn’t apply.

v Resources Controlled By

This option is used to set whether the system is permitted to automatically

distribute IRQ DMA and I/O addresses when each time that the machine is

turned on. The setting values are: Disabled and Enabled.

vIRQ Resources

Press the <Enter> key, then manually set IRQ resources.

vPCI/VGA Palette Snoop

If you use a non-standard VGA card, use this option to solve graphic accelera-

tion card or MPEG audio card problems (e.g., colors not accurately displayed).

vINT Pin 1-8 Assignment

This option is used to name the interrupt request (IRQ) line assigned to a

device connected to the PCI interface on your system.

vMaximum Payload Size

This option is used to set maximum TLP payload size for PCI Express devices.

The unit is byte.

PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn

Foxconn 945G7AD User Manual

Questions and Answers: