15
4-4 Channel of Operation
By default, both the caller and the remote are set to channel 4, from
the factory. If the two devices are not on the same channel, then radio
communication will not be possible. In order to change the channel of
operation of the HellCat Pro, you will need to connect it to a computer
and use the FOXPRO Programming Utility.
4-4 Smart Light
With Smart Light technology, you can control your FOXPRO hunting
light with the Hellcat Pro remote control. Instructions on how to
connect to and control the light are outlined in the manual that is
included with the light.
4-5 Sound Settings
The sound settings menu allows you to select how the Hellcat Pro plays
your sounds, how the speakers work, and so forth. This section will
explore each of the options, their values, and how they affect
operation.
Volume Steps
The Hellcat Pro remote has a range of volumes from 0 – 30. Increasing
the volume in the field by increments of 1 may be too slow for some
and therefore this stepping value is configurable. You can choose from
1, 2, and 3. The factory default setting is 2.
Primary Mode
There are three different modes in which the Hellcat Pro will play
sounds: Repeat, Single, and Jukebox.
• Repeat (default play mode) – In Repeat play mode, the caller
will play the current sound until the end of the sound file, then
automatically start playing it again until it is changed by the
user.
To Next Page
Loading...
