19
The alarm is based upon the stand timer only, not the real time clock.
Keep in mind that the stand timer begins tracking time as soon as the
Hellcat Pro remote is turned on. Make sure that you select the Stand
Timer Reset option (described earlier on this page) when setting up the
alarm. For example, if you turn on the Hellcat Pro remote and 10
minutes have passed while getting setup, and then you set the alarm
for 30 minutes, it’s going to go off 20 minutes later unless you use the
Stand Timer Reset prior after setting the alarm. Also, if the screen
timeout occurs prior to the alarm going off, it will turn back on when
the alarm goes off.
Time
The Hellcat Pro remote has a real time clock. This clock must be set
when you first install or change batteries. The clock can be displayed in
either the standard 12-hour format or 24-hour format (military time).
The bottom status line of the Hellcat Pro display can show either the
current time or the stand timer. The stand timer will only be displayed if
it is turned on—otherwise, the clock will show the current time.
Date & Time Format
The Hellcat Pro remote will keep track of the current date. This needs to
be setup when you first start using the Hellcat Pro remote. There are
three different date formats that you can choose from depending upon
your personal preference. They are month/day/year, year-month-day,
and day.month.year.
4-8 TX1000 Settings
The TX1000 Settings menu allows you to change the radio channel, download
the sound list, and configure other options.
Radio Channel
The Hellcat Pro remote can be configured to operate on one of 8
different radio channels (0-7). If you change the radio channel for the
To Next Page
Loading...
