7
1-3 Charging the HellCat Pro
After you have the battery installed, MAKE SURE THE CALLER IS TURNED
OFF and any accessories (external decoy, USB cable) are disconnected.
Plug your charger into the charge jack on the front of the caller and
connect the other end to a 120V AC wall plug. At the end of the
charger, you will notice a glowing red light. This means the battery pack
is charging. The light will turn green once the battery is fully charged. It
takes roughly 6 hours to charge a fully depleted battery pack.
Note: There are some instances where the red charging light will slowly
blink before turning solid red. This is perfectly normal.
General Precautions and Warnings for Charging
• Never attach an unapproved or a non-FOXPRO® charger to your
Hellcat Pro battery pack! Damages caused by plugging
unapproved charging devices into your Hellcat Pro will not be
covered by the warranty.
• Never connect your Hellcat Pro to an unregulated 12V system
(i.e., automotive systems, high current power supplies, etc.)
Serious damage will occur which is not covered by the warranty.
The charge jack is intended only for FOXPRO® chargers.
• Never attempt to charge batteries that are not intended to be
recharged! This includes both Zinc Carbon and alkaline cells. The
resulting damage can be serious and will not be covered by the
warranty. For maximum charge efficiency, we recommend
charging your Hellcat Pro in temperatures ranging from 40°F to
85°F (5°C to 30°C).
• Disconnect any/all accessory devices that may be attached to
the Hellcat Pro prior to charging. This includes auxiliary devices,
and USB cables.
• Make sure that the rechargeable battery pack is installed in the
Hellcat Pro properly.
To Next Page
Loading...
