18
When your display times-out, you can push the power button a single
time to wake it back up to ensure that no functions are initiated. For
example, if you were to use a preset button or mute button in attempt
to wake the remote up, you will be performing the function of that
button at the same time. A single press of the power button will wake it
up without causing any changes in operation.
Auto Off
After being idle for an established period, the Hellcat Pro remote
control will completely power down. When this happens, the remote
must be powered back on like normal. There are five different time
settings that you can use for configuring the auto power off: 30
minutes, 45 minutes, 1 hour, 2 hours, and 4 hours.
4-7 Date/Time(r)
The Date / Time(r) menu provides access to the date and time
configuration, stand timer configuration, and the stand alarm.
Stand Timer & Timer Reset
When activated, the far-right indicator on the bottom status line will
begin keeping time that has elapsed since the Hellcat Pro remote has
been powered on. The timer displays as: “MMM: SS” (“M” stands for
minutes and “S” for seconds). The stand timer begins tracking time as
soon as the Hellcat Pro remote is turned on.
Alarm
The Hellcat Pro remote features a visual alarm that can be set to go off
after a span of time. The available times are represented in minutes: 1 –
60. When the alarm is set and the configured time span passes, the
stand timer (or clock if set to display the clock) will begin to flash
alerting you.
To Next Page
Loading...
