11
observing correct polarity as indicated. Slide the battery compartment
door back on the remote.
Turning on the HellCat Pro Remote & Basic Setup
To turn on the HellCat Pro remote control, push down the power
button for about 1-2 seconds. The screen will display startup
information briefly before going to the main view. Every time you
replace batteries in the HellCat Pro remote, it’s a good practice to
update the date and time settings.
2. Quick Start Guide
Important Note: The HellCat Pro remote control is not intended to
operate the caller at distances shorter than 1 meter (3 feet). If the
remote is too close to the caller, proper operations cannot be ensured.
2-1 Playing Sounds
Turn on the Hellcat Pro by sliding the power switch to the “On”
position. Notice the pilot light will illuminate green. The pilot light also
acts as a low battery indicator. If the green light is turned on, but it
blinks during use, it indicates that the battery pack will need to be
recharged. Turn on the Hellcat Pro remote by pushing and holding the
power button for approximately 1-2 seconds. When powered on, the
Hellcat Pro remote default view will display the available categories.
Using the scroll buttons on the Hellcat Pro remote, highlight the
category you wish to pick a sound from, and then push the
“Play/Select” button. The sounds assigned to that category will now be
displayed. Use the scroll buttons to highlight a sound that you wish to
play, and then push the “Play/Select” button to begin playback. You
then must use the volume up button to raise the volume level to your
desired setting.
To Next Page
Loading...
