NT200 OBDII/EOBD Code Reader User’s Guide_English Version_V1.10
need to be driven and the monitor ran before
concluding that the fault is repaired.
√ This function is performed with KOEO. Do not start the
engine.
To erase codes from vehicle control modules:
1. Use the SCROLL key to select Clear Codes from
Diagnostic Menu
screen.
2. Press the YES/NO key to confirm.
3. If codes and diagnostic results are to be cleared, use
the SCROLL key to select YES and press the YES/NO
key.
√ If codes and test data not to be deleted, select NO, and a
“Command Cancelled!” message displays prompting to
press any key to return to
Diagnostic Menu
.
4. Wait a few seconds until a “Codes Cleared!” message
shows indicating codes are cleared successfully.
√ If the code reader fails to clear the codes, a “Clear Error!
Turn Key on with Engine off!” message displays.
5. Wait a few seconds or press any key to return to
Diagnostic Menu
.
Diagnostic Menu
Read Codes
Clear Codes
Datastream
Freeze Data
Clear Code
Are You Sure to
Clear Codes?
<YES> NO
To Next Page
Loading...
