NT200 OBDII/EOBD Code Reader User’s Guide_English Version_V1.10
3. Press the YES/NO key to confirm.
4. View DTCs and their definitions.
√ If no DTCs are present a message stating “No (Pending)
Codes Found” is displayed.
√ If any manufacturer specific or enhanced codes detected,
a “Manufacturer specific codes are found! Press any key
to select vehicle make!” message displays prompting
you to select vehicle make before viewing DTC(s).
√ If manufacturer of the vehicle being tested is not list,
select Other.
5. Press the YES/NO key to return to
Diagnostic Menu
screen.
5.2 Clearing DTCs
The
Clear Codes
function is used to delete DTCs and I/M
Readiness data from vehicle’s control module(s). It may also
erase freeze data, and set monitors to incomplete or not ready.
√ Perform
Clear Codes
function only after systems have
been checked completely.
√ After servicing the vehicle, erase stored DTCs and verify
no codes have been reset. If a DTC returns, problem
has not been fixed or other faults are present.
√ Depending on which monitor sets a code the vehicle may
$10 1/2
P0101 Generic
Mass or Volume Air
Flow A Circuit Range
/ Performance
Diagnostic Menu
Read Codes
Clear Codes
Datastream
Freeze Data
To Next Page
Loading...
