Foxwell NT200 - Safety Information; Conventions Used; Important Safety Instructions

NT200 OBDII/EOBD Code Reader User’s Guide_English Version_V1.10
5
2. Safety Information
For your safety, and to prevent damage to the equipment and
vehicles, read this manual thoroughly before operating your
NT200 code reader. The safety messages presented below and
throughout this user’s manual are reminders to the operator to
exercise extreme care when using this device. Always refer to
and follow safety messages and test procedures provided by the
manufacturer of the vehicle or equipment being tested. Read,
understand and follow all safety messages and instructions in
this manual.
2.1 Conventions Used
We provide safety messages to help prevent personal injury and
equipment damage. Below are signal words we used to indicate
the hazard level in a condition.
No.
Signal Word
Hazard Level
1
Indicates an imminently hazardous
situation which, if not avoided, will
result in death or serious injury to the
operator or to bystanders.
2
Indicates a potentially hazardous
situation which, if not avoided, could
result in death or serious injury to the
operator or to bystanders.
3
Indicates a potentially hazardous
situation which, if not avoided, may
result in moderate or minor injury to the
operator or to bystanders.
2.2 Important Safety Instructions
And always use your code reader as described in the user’s
manual, and follow all safety messages.
Do not route the test cable in a manner that would
interfere with driving controls.
Do not exceed voltage limits between inputs
specified in this user’s manual.
Always wear ANSI approved goggles to protect