Foxwell NT414 - System Selection; Auto Scan

17
AutoMaster Pro NT414 Manual_English_V1.00
Figure 4-12 Sample tested vehicle identification screen
2. Select the vehicle under test and press the ENTER key.
4.2 System Selection
When you have completed the identification of vehicle, a menu for selecting system to test
displays. Menu options typically include:
● Auto Scan
● Control Unit
4.2.1 Auto Scan
Auto Scan performs an automatic system test to determine which control modules are installed on
the vehicle and obtain diagnostic trouble codes (DTCs) overview. Depending on the number of
control modules, it may take a few minutes to complete the test.
To perform an automatic system scan:
1. Scroll with the arrow keys to highlight Auto Scan from the menu and press ENTER to start.
Figure 4-13 Sample Select System Scan Screen
2. To pause the scan, press the function key corresponding with Pause on the screen.
Figure 4-14 Sample Automatic system scan screen
3. At the end of successful automatic controller scan, a menu with a list of installed controllers
together with their DTC overview displays.