FPI P36D-NG - Page 50

FPI P36D Zero Clearance Direct Vent Gas Fireplace
50
REGENCY OPTIONS
3) Install the hinges to the hinge brackets on the left and right side of
the bottom of the outer frame, secure using 2 x #8 Philips Head
Screws per hinge.
4) Place the Bottom Grill near hinge. Flip the hinge over the Bottom Grill
and secure with 3 x #8 Philips Head Screws per side.
Bottom Grill
Hinge Location
6) Slide the Top Grill into the louver brackets located on the inside top
of the firebox. Push in place.
Top Grill
8) Close screen doors.
7) Install the Left and Right Side Screen Doors in the fully open position
by placing over top of the hinges on the Full Screen Door Frame.
NOTE: Failure to install the doors in the fully open position could result
in paint damage to the surface of the door.
Hinge
Screen Door
Burner ON/OFF
Control Box
5) Mount the Burner ON/OFF Control Box to the left side of the Bottom
Grill using 2 x #8 - 1/4" Philips Head Screws.
Left Side
of Bottom
Grill
Loosen the 3 screws which secure the Right Side Hinge Bracket to
the Bottom Grill. Place the keyholes in the Restrain Bracket through
the screws and slide the Bracket to the right. Tighten the screws to
secure bracket in place.
Right Side
of Bottom
Grill
Restrain
Bracket
Hinge
Bracket