7
Safety and Warning Notices.
Important !
Read this before commissioning !
■ The operating instructions should be read carefully before the device is assembled,
installed and put into operation.
■ Installation and commissioning should only be carried out by appropriate specialists in
accordance with existing regulations and provisions
■ The operator must ensure that all operatives are familiar with these operating instructions
and proceed accordingly
■ The device conducts mains voltage and should not be opened
■ If the device is obviously damaged, it should not be installed, connected or commissioned
■ If the device does not work after commissioning, it should be disconnected from the mains
again
■ Any other laws, standards, guidelines, etc. regarding this product must be observed
The commissioning and safety information for the power factor correction system should
also be observed.
za
voshelectric.ir
To Next Page
Loading...
