Framery O
4. Push the counterpart handle onto the spindle and attach the handles with M5x32
screws (2 pcs) from the inside.
Use a manual screwdriver to tighten the screws. Do not overtighten.
If the handle does not return easily to the starting position, loosen the screws slightly
and check the handle function again.
Note: Turn the screw holes on the handle to correspond to the ones on the
door.
Note: Make sure that there is no gap between the cover plates and the door.
Complete care instructions
info@frameryacoustics.com
33
To Next Page
Loading...
