Framery O
4. If you installed the power cord to the floor module, install the lead-through rubber to the
right-hand bottom body cover.
Bend the rubber into shape before installing it.
Note: You only have to do this when installing for the first time.
5. Slide the right-hand bottom body cover under the pod.
Note: If you installed the power cord to the floor module, guide it through the
lead-through and support it while sliding the body cover into place.
6. Guide the body cover folds into the installation grooves.
46
Complete care instructions
info@frameryacoustics.com
To Next Page
Loading...
