Framery O
2. Press the body cover into the upper groove with one hand and bend the body cover
lightly outward with your other hand. Slide the lower edge of the body cover into the
groove at the bottom of the wall and press the body cover into place.
Note: Make sure that the power cord is not damaged.
Note: Align the cover to the door frame and the floor body covers.
Note: Make sure that there are no gaps between the body cover and the door
frame.
Note: Make sure that the body cover is installed evenly and aligned correctly.
Use a white rubber mallet to tap the wall covers into alignment if needed.
3. Repeat the steps for the other wall body cover.
Complete care instructions
info@frameryacoustics.com
51
To Next Page
Loading...
