Franke 600 - Instructions for Use; Function Switch; Care and Maintenance

INSTRUCTIONS FOR USE
FUNCTION SWITCH
A B C D E
Fig. 6
A. Lighting.
B. Ventilation mode. The extractor fan runs
on low speed for 60 minutes.
C. Speed 1 on fan motor.
D. Speed 2 on fan motor.
E. Speed 3 on fan motor. If the button is
held in for 2 seconds, the fan switches
to intensive mode. After 7 minutes, the
fan motor returns to its previously set
mode. The fan can be started and stop-
ped with buttons B-E.
It is a good idea to turn on the hood before
starting to cook, as this prevents cooking
smells spreading into the room. Adjust the
speed of the hood depending on the type of
food you are preparing. If possible, allow
the hood to run at a low speed for a few mi-
nutes after you’ve finished cooking. You
may also wish to run the hood on the low
setting when the oven is in use or after us-
ing the dishwasher.
CARE AND MAINTENANCE
Cleaning
The cooker hood should be cleaned with a
damp cloth and washing-up liquid. With nor-
mal usage, the filters must be cleaned at
least every other month. Clean more often
after intensive use.
Fig. 7
Remove the grease filters by opening the
snap retainer, Fig. 7 Handle the filters care-
fully, taking care not to bend them.
Soak the filter in a solution of warm water
and washing-up liquid. The filter can also be
washed in a dishwasher.
Refit the grease filters after cleaning, mak-
ing sure they snap firmly into place.
B
A
Fig. 8
The impeller, side grilles and fan interior
must be cleaned at least twice a year.
The motor core is removed by first discon-
necting the contact on the side of the mo-
tor unit, Fig. 8A. Rotate the latches, Fig. 8B,
that lock the motor core in place. Pull the
unit outwards so that it is freed from the
pins, and then downwards.
Attention!
The motor core should not be washed or
exposed to moisture!
12
991.0357.786/D000000006688/180157/2021-09-24