1T 310'177 Operating Manual Ecolino Erstellt: 01.05.2002 Rev.: C SL: 20'987 BJC
page 41
3. Press the Shift key delete card
You are asked to confirm that the Free Card table is delete? "shift"
to be cleared. If this is not the case, change to the
Management level with the "+" or "-" key
4. Press the Shift key delete free card
All registered Free Cards are cleared ...done...
delete free card
perform "shift"
6.1.5.11 Change PIN-code
1. Insert the Management Card into the card reader
2. Press the "+" or "-" key until the parameter is obtained change pin-code
perform "shift"
3. Press the Shift key pin-code 0000
"-/+" "shift" à
4. Digits are entered using the "+" or "-" key. The next item is obtained using the Shift key.
5. After the input, the new PIN code is saved to the change pin-code
Mangagement Card ... done....
6.1.6 Load Card
- Load Chip Cards
- Clear Chip Cards
- Chip Card loads
- Chip Card information
- Enable Chip Cards
- Disable Chip Cards
- Change PIN code
6.1.6.1 Handling of the Load Card
If the Load Card has not yet been assigned to the Ecopower (setting made at the factory), you will
be requested to input the installation number when you insert the Load Card into the chip card reader
for the first time. The installation number appears on the rating plate under the identification no.
During input, the Stop key is used to increase the number and the Clean key to reach the next digit
position. This input is no longer requested on subsequent use of the Load Card.
1. After insertion of the Load Card, the PIN code is scanned depending o the security level
pin-code 0000
"-/+" "shift" à
2. Digits are input with the "+" or "-" key. The next item is obtained using the Shift key.
3. Once the PIN code has been correctly entered, the Load level is reached.
4. If the Pin code is incorrectly entered, the Load Card must be removed and reinserted. Input of the
PIN code can now be repeated from point 1.
To Next Page
Loading...
Need help?
General
