1T 310'177 Operating Manual Ecolino Erstellt: 01.05.2002 Rev.: C SL: 20'987 BJC
page 43
4. Insert the Cash Card into the card reader cash card
The user is asked to confirm that the Cash Card is to delete? "-"
be cleared. If this is not the case, remove the Cash Card
and insert the Load Card into the card reader.
5. Press the "-" key delete cash card
The credit on the Cash Card is cleared ...busy...
6. Remove the Cash Card remove card
7. If further Cash Cards are to be cleared, steps 4 to 6 insert card
must be repeated cash/load à
8. Insert the Load Card into the card reader delete chip cards
perform "shift"
6.1.6.4 Chip Card Loads
The total loaded amount is displayed and can be cleared.
1. Insert the Load Card into the card reader
2. Press the "+" or "-" key until the parameter is obtained chip cards loading
turn-over XX.XX
If it is intended to clear the total oaded amount, the following procedure must be adopted:
3. Press the Shift key delete chip cards
delete? "-"
4. Press the "-" key so that the total loaded amount is chip cards loading
cleared turn-over 00.00
5. By pressing the "+" or "-" key, the Management level
is reached.
6.1.6.5 Chip Card Information
If a Cash Card is lost, the owner can be found by means of the card number. This of course assumes
that all card data and users are registered.
1. Insert the Load Card into the card reader
2. Press the "+" or "-" key until the parameter is obtained info chip cards
perform "shift"
3. Press the Shift key remove card
delete? "-"
insert card
cash/load à
To Next Page
Loading...
Need help?
General
