F3D3 Series Service Manual Factory Level 3 Parameter Access / 1.11.3
Questions? Call Franke Technical Support Group For Your Area. Copyright 2012 Franke, Inc. All rights reserved.
Factory Level 3 - Parameter Guide – Page 1
[For Models with firmware version F3D3 Main H46P9 ONLY
1)
]
5=French/English (Canada)
Temperature offset from sensor
Temperature that triggers a high
High Alarm (Start
Up) Delay
Time to wait after high alarm
signal, until message appears
Temperature must remain (dwell)
Used in temperature control
Used to correct onboard time
keeping.
Minimum time the compressor
must be off before restarting.
Time for a size downshift from
large to medium. 20 = Off
Time for an initial size downshift
from medium to small. 20 = Off
Time for subsequent size downshift
from medium to small. 20 = Off
Motor stops if threshold exceeded.
Approx 250 counts/amp of motor
Motor stops if threshold exceeded.
Approx 250 counts/amp of motor
Motor stops if threshold exceeded.
Approx 250 counts/motor current.
NOTES: 1) Software version is printed on label on Main Control Board Chip.
2) Country Exceptions Abbreviations: US = North America; EU = Europe; JP = Japan; LA = Latin
America (South & Central); CN = Canada; AP = Asia, Pacific, Middle East & Australia